detroit Posted November 3, 2008 Share Posted November 3, 2008 ...htio bi napraviti prednju sajbu od pleksija za demsa...pa me zanima jel se on da pigat jer se sajba od sredine savija...plan je uzeti pleksi debljine 2-3mm izrezat ga na mjere I posredini zagrijat I malo popigat...jel to izvedivo?? Link to comment Share on other sites More sharing options...
Veki Posted November 3, 2008 Share Posted November 3, 2008 tak tanki se piga malo sam po sebi mislim..bar onaj neki iz bauhausa kad sam ja kupovao. al ne vidim baš poantu toga..kolko može imat prednja šajba ..10 kila ? ..al to je 10 kila stakla koje se neće rasipat u slučaju nekog sranja...pleksi kad pukne pukne u oštre komade Link to comment Share on other sites More sharing options...
detroit Posted November 3, 2008 Author Share Posted November 3, 2008 ...to je za kamion jel su mi strunuli orginal nosaci sajbe..pa cu samo pleksi naljepit... Link to comment Share on other sites More sharing options...
Veki Posted November 3, 2008 Share Posted November 3, 2008 aha , ja mislio za drugi opel :lol: hmm..al ovisi kakva je šajba.. mislim da je ok sak je samo recimo po širini spigana..ali ako je i po visini i po širini brijem da će bit problema Link to comment Share on other sites More sharing options...
vjeko Posted November 3, 2008 Share Posted November 3, 2008 radije leksan ak ga nadjes umjesto sajbe koristi.. jer bas ovo kaj ti Veki veli - pleksi puca u ostre komade i moglo bit sranje nedaj Boze.... Link to comment Share on other sites More sharing options...
Marko Posted November 3, 2008 Share Posted November 3, 2008 http://www.plasticsmachining.com/magazine/199609/polycarbonate.html http://www.portplastics.com/architect/page22.html akril puca, polikarbonat ne puca Link to comment Share on other sites More sharing options...
detroit Posted November 3, 2008 Author Share Posted November 3, 2008 ...ma nek puca...to opce nije bitno...skoncentrirajte se na moje pitanje.... ...o ovom se radi... Link to comment Share on other sites More sharing options...
Marko Posted November 3, 2008 Share Posted November 3, 2008 skoncentriraj se na odgovore, :P:P na onim stranicama imas postupke obrade polikarbonata , minimalne radijuse zakrivljenosti i take pizdarije Link to comment Share on other sites More sharing options...
detroit Posted November 3, 2008 Author Share Posted November 3, 2008 ...hvala na linkovima...surfam na mobu na predavanju pa nisam u mogucnosti to proucavat al budem kad dodem doma... Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now